dunnleed08
11-21-2006, 08:08 AM
jus looking through the cpu database on this sight and noticed that it says that my cpu's volts are suppsoed to be 1.425...but my abit is-10 runs at standard of 1.325......can't beleive i didn't notice before,,,,,my old school mobo does have a cpu voltage jumper to raise it .10 volts, I did this, but now...when i run the little x-wing on atitray tools while running abit eq(abits old mobo monitoring prog...) the prog. blips quite a bit. (it beeps when there is an error, like unstable volts or temps that are too high........does anybody know why this might be???please??............because it does seem to run faster while the voltages are raised....tray tools benching went up by about 200 points..(not too much...but good for a poor gamer like myself)....
btw i thought that the pwm's were getting too hot, because they ran at 80 celsius befoe i raised the volts, but i turned of that aspect of the monitor prog. and it was still beeping
....basically what i wanted too know is if my cpu hasn't benn operationg to full potential this whole time...and now that it's on the right volts and not working properly...does that meen that my mobo's not fully compatible??
btw i thought that the pwm's were getting too hot, because they ran at 80 celsius befoe i raised the volts, but i turned of that aspect of the monitor prog. and it was still beeping
....basically what i wanted too know is if my cpu hasn't benn operationg to full potential this whole time...and now that it's on the right volts and not working properly...does that meen that my mobo's not fully compatible??