Emachines T2200

[ethiosen]

eMachines T2200 Power is up but nothing else(no video) what else need to be checked. How can I reset it.It is on board video.

[AthlonX2]

is this onboard video,or a graphics card? make sure your connection with the vga cable is nice and snug on both ends

[vrm4]

mayber check the bios and ensure that the onboard video is not disabled.

[AthlonX2]

if he cant see the screen he wont be able to tell if the onboard is disabled,looks like maybe a cmos reset would do the trick if thats wrong? should have a jumper near cmos battery pull the battery out and switch the jumper to pins 2 and 3,leave there for a few minutes and switch it back....and make sure you unplug the pc before doing this:toast:

[ethiosen]

I tried all the above still cant get to the screen help

[Magnolia00]

I'm having the exact same problem. I get no video and no POST beeps either. I even went and purchased a board of the same model, L7VMM2 V 1.0A, on Ebay and that turned up worse. With that board nothing powers up at all...nothing. Could it be bad memory? I figured if it was bad at least I would get a beep code. That doesnt happen though. Any thoughts on this anyone?

[Jimmy 2004]

Bad memory would still give an error. This is probably linked either to the power supply or motherboard, possibly the graphics although I'd expect that to give an error code.

Have you got another computer you can swap some parts with or a friend to borrow a power supply from? Check all the power connections are tight.

[SlipSlice]

yea, I would say check your power supply, if the video won't load up, it might need some more power...but then it could be a bad graphics card.

[sneekypeet]

what exactly is powered up mean? lights(where) are the fans runnin? did u just move the comp? is there a DVI/VGA switch on your montior or in the settings(options)


just trying to clear out the simple things is all!!!