PDA

View Full Version : How to permanently change x800xt fan speed

bit_image
08-30-2005, 06:48 PM
I modded my X800 to an x800pe, and installed a Silencer 4 on it, which works great. However, I wish to run the fan at higher speed than the 43% that it normally runs at. I would like to know if there is a bios tweak that will allow the fan to run higher, or even 100%. I dont want to use software all the time to change the speed.
W1zzard
08-30-2005, 09:37 PM
there is no way because nobody has figured out where/how the bios stores the fan control information
bit_image
08-31-2005, 03:02 AM
Well, is there a hardware method? I wish that someone would create a bios flash to increase the fan speed!!!!!
W1zzard
08-31-2005, 09:21 AM
if you want to run it at 100% disconnect the fan power from the video card and connect the fan wire to 12v from the psu
Christer
08-31-2005, 01:23 PM
Why the f**k don't you use ATI Tool? Thats what I did.....
AceFactor
08-31-2005, 02:02 PM
Christer. .you really should read before you reply! :D

Before having a go. .the guy obviously said he didnt what it to be software controlled. .and the last time i checked, ATi Tool was a program :)

Adam
Weigy104
08-31-2005, 09:18 PM
you can set ati tool to boot up when your comp starts and load a profile so in that profile just set the speed to 100%. thats the only way i can think of. :confused: