Overclock settings not working in 3DMark05

[Wile E]

I'm having a hard time with 3DMark05 and Rivatuner it seems. I set my clocks in RT, and all looks well, my clocks go to where I set them. Then, when I run 05, the gpu/shader clocks go back to BIOS defaults during the tests (mem stays OCed), but clock back up in between tests or when idle. Anybody else have this problem, or know a work around?

[dark2099]

I had a similar problem with 06 and Vantage where my Core would stay at the overclocked speed, but the memory would reset, also I was using ATI Tool rather than RT.

[erocker]

If you are using the newest rivatuner, perhaps try an older version? Just throwing that out there.

[nflesher87]

I think it has something to do with your vmod and the high clocks you're running
while reading up on the vmod I've seen others with the same issue

[Wile E]

If you are using the newest rivatuner, perhaps try an older version? Just throwing that out there.I tried 2.06-2.09 with the same results.

I think it has something to do with your vmod and the high clocks you're running
while reading up on the vmod I've seen others with the same issueReally? Anybody resolve the issue? The clocks work fine for me in Vantage and 06. Haven't fully tested in 03 or 01 yet. I was working my way down. lol. I hope I don't have to resort to a million BIOS flashes. lol.

[nflesher87]

I tried 2.06-2.09 with the same results.

Really? Anybody resolve the issue? The clocks work fine for me in Vantage and 06. Haven't fully tested in 03 or 01 yet. I was working my way down. lol. I hope I don't have to resort to a million BIOS flashes. lol.

I didn't look that far into it sorry man, I'd check here: http://www.xtremesystems.org/forums/showthread.php?t=163929
or just PM largon directly

[Wile E]

Well, I got it sorted. I just flashed the card so all clock states were 900/2268/1053. :roll:

[nflesher87]

lol fair enough :p