Crash on exit

[Docnsane]

Systool Always crashes on exit. It has been happening since I started using this application (version 631)

From the Event Viewer Application log

Faulting application systool.exe, version 1.0.0.633, faulting module unknown, version 0.0.0.0, fault address 0x01fb9bab.


System specs
WinXP x64-SP1
AMD Athlon 64 X2 Dualcore 3800
4GB Ram
AsRock 939Dual-SATA2
300Gig Sata150
120GB IDE
30GB IDE
GF-6800nu AGP

Logfile of a load-exit-crash cycle.
2006-01-11 23:01:39 I SysTool v1.0 Build 633 starting...
2006-01-11 23:01:39 I *******************
2006-01-11 23:01:40 D Successfully connected to driver, version 124
2006-01-11 23:01:40 D ALi M1563 found at 0x400.
2006-01-11 23:01:40 D Found NVIDIA device: 0x10DE 0x0041 bus 3 dev 0
2006-01-11 23:01:40 D fbPhy: 0xFC000000, mmrPhy: 0xFD000000.
2006-01-11 23:01:40 D mmapped mmr to 0x2520000
2006-01-11 23:01:40 D F75373 temp chip detection: failed (VendorID)
2006-01-11 23:01:40 D Found NVIDIA device: 0x10DE 0x0041 bus 3 dev 0
2006-01-11 23:01:40 D fbPhy: 0xFC000000, mmrPhy: 0xFD000000.
2006-01-11 23:01:40 D mmapped mmr to 0x3520000
2006-01-11 23:01:40 D F75373 temp chip detection: failed (VendorID)
2006-01-11 23:01:40 E HDDTemp.dll: SMART_RCV_DRIVE_DATA failed
2006-01-11 23:01:40 D HDDTemp.dll: SMART_RCV_DRIVE_DATA ok
2006-01-11 23:01:40 E HDDTemp.dll: SMART_RCV_DRIVE_DATA failed
2006-01-11 23:01:40 I LM78.dll: LM78 found at 0x290
2006-01-11 23:01:40 D LM78.dll: LM78 type: W83627HF