szlovak
02-27-2006, 01:05 PM
Hello
I don't overclock this card and get this message. When scanning for artifacts, there is always "2 pixels don't match" in AtiTool on standard settings. It happens after 15 seconds to about 20minutes (I didn't wait longer, fresh started computer). I checked CPU with Prime (it's OK). Drivers are from Omega site, the newest 3.8.221 . Card is from Sapphire, 256 bit. Is this card OK? I played Doom 3 on core @406MHz with no even single artifacts visible (1/3 of the whole). And Far Cry at deafault core. Is it normal and I just should move the slider to right in "scanning artifacts" settings? Or it can be the power supply .
Please help
I don't overclock this card and get this message. When scanning for artifacts, there is always "2 pixels don't match" in AtiTool on standard settings. It happens after 15 seconds to about 20minutes (I didn't wait longer, fresh started computer). I checked CPU with Prime (it's OK). Drivers are from Omega site, the newest 3.8.221 . Card is from Sapphire, 256 bit. Is this card OK? I played Doom 3 on core @406MHz with no even single artifacts visible (1/3 of the whole). And Far Cry at deafault core. Is it normal and I just should move the slider to right in "scanning artifacts" settings? Or it can be the power supply .
Please help