View Single Post
Old 10-31-2008, 04:35 AM     #255
Fitseries3
Eleet Hardware Junkie
 
Fitseries3's Avatar
 
Join Date: Oct 2007
Location: ATX
Posts: 11,918 (15.34/day)
Thanks: 3,284
Thanked 2,216 Times in 1,604 Posts
Send a message via Skype™ to Fitseries3

System Specs

1. install all drivers and get everything working.

2. have both monitors up and running.

3. right click desktop and go to display properties and select display settings(adjust resolution).

4. make sure both vid cards have a desktop enabled, ONLY ONE.

5. select the nvidia card as your default/main desktop/monitor and hit APPLY(not ok, leave the window open)

6. open physx control panel and go to the physx card tab. it should now say physx is enabled. leave this open.

7. switch the default/main display back to the ati card(s) and hit apply.

8. in the physx control panel, click on ENABLE a few times so that APPLY becomes available once again. click apply and repeat this step again.

9. run your benchmark of physx enable games.

10. enjoy.

NOTE: the monitor on the physx card does not need to be left on at this point.
__________________
““The best engine in the world is the vagina !!It can be started with one finger, is self-lubricating, takes any size piston and changes its own oil every four weeks. It is only a pity that the management system is so f***ing temperamental!!!””
Fitseries3 is offline  
Reply With Quote
The Following 6 Users Say Thank You to Fitseries3 For This Useful Post: