- Joined
- Feb 5, 2008
- Messages
- 120 (0.02/day)
System Name | MONSTER |
---|---|
Processor | Core2 Quad Q6600 G0 @3.6GHz (9x400MHz) 1.35v |
Motherboard | Gigabyte GA-P35-DS4 Rev. 1.0 |
Cooling | Home-made water cooling + 3x120mm 1200rpm case cooling |
Memory | 4x1GB Kingmax DDR2-1066 @ 1000MHz CL4 5-5-16 |
Video Card(s) | Asus EN8800GTS (g92) 512MB @core:783, shader:1944, video ram:1044 |
Storage | 2x250GB Hitachi 8MB 7200RPM SATA2 RAID0 + WD 400GB 16MB 7200RPM SATA2 |
Display(s) | Samsung 226BW 22" 1680x1050 2ms |
Case | Custom Made |
Audio Device(s) | Creative Labs Audigy X-Fi XtremeMusic |
Power Supply | Spire Rocketeer 600W |
Software | Vista Ultimate 64 & 32 bit; Windows XP Pro 64 and 32 bit |
Benchmark Scores | 17645 3D Mark 2006, http://service.futuremark.com/compare?3dm06=4995796 |
Since we have no storage section, I'm posting this here because it had happen due to OC.
I was trying to break 18K 3D Mark 2006 and I set the PCI-e clock to 130. Something went wrong and the mainboard BIOS was reseted and the RAID0 array broken. I am using 2x250GB Hitachi SATA2 8MB on the gigabyte RAID controller on my P35-DS4. One of the drives is recognized as RAID-Inside, while the other is recognized as Non-RAID.
I have my OSes and lots of softwares installed on these drives
Although I have backup of almost all the data on these drives, I'll need a week to install and tweak everything like before. I turned off the PC and I haven't written anything to the HDs.
The Gigabyte RAID software allows me only to remove the drive from RAID or to convert(whatever it means) it in non-RAID.
Is there any way to rebuild the RAID array without loosing the data?
I was trying to break 18K 3D Mark 2006 and I set the PCI-e clock to 130. Something went wrong and the mainboard BIOS was reseted and the RAID0 array broken. I am using 2x250GB Hitachi SATA2 8MB on the gigabyte RAID controller on my P35-DS4. One of the drives is recognized as RAID-Inside, while the other is recognized as Non-RAID.
I have my OSes and lots of softwares installed on these drives
Although I have backup of almost all the data on these drives, I'll need a week to install and tweak everything like before. I turned off the PC and I haven't written anything to the HDs.
The Gigabyte RAID software allows me only to remove the drive from RAID or to convert(whatever it means) it in non-RAID.
Is there any way to rebuild the RAID array without loosing the data?